Lovely, wont have struggled much with that though!Giving the but in the middle a whirl
It knows it's behind it . 10k is about as much as it can do if it had duals you might get a bit more . I was only on it a wee while getting it set up then the boss took it and he wasn't flying up the hill anyway.Lovely, wont have struggled much with that though!
thoughts?It knows it's behind it . 10k is about as much as it can do if it had duals you might get a bit more . I was only on it a wee while getting it set up then the boss took it and he wasn't flying up the hill anyway.
It's near enough a match for our re mapped 7930 I'd say .thoughts?
Is it command pro?Giving the but in the middle a whirl
Thankfully no . Premium spec standard autopowerIs it command pro?
Thought now possibly you use to the fast track you might want that everything on the joystick!Thankfully no . Premium spec standard autopower
To be honest I only like the fastrac joystick because it's a t**t to drive without it as everything is too scattered around the armrest.Thought now possibly you use to the fast track you might want that everything on the joystick!
Does the 5465 have the bigger rams on? I can’t remember the sizes off hand but ours originally had the smaller ones fitted, I want to say 65mm and you can swap them fit the bigger ones off say a 6480 etc, I’m pretty sure it was 10mm in diameter bigger but made it lift over a ton more. Ours was the older shape with top link sensing they may have fitted the bigger ones later as standard however .Its not the pullin of the plough thats the problem its the liftin it. Iv a 5465 on a heavy 4 furrow and it struggles big time to lift it
What do you think ?Giving the but in the middle a whirl
Aye it's alright.What do you think ?
Aye it's alright.
Goes well enough it's just a bigger version of the 155 we had but doesn't run as hot and actually pulls well .
Its 300hp on a 4m drill it shouldn’t know it’s theirAye it's alright.
Goes well enough it's just a bigger version of the 155 we had but doesn't run as hot and actually pulls well .
It knows it's there alright but so does our 300 +hp 7930Its 300hp on a 4m drill it shouldn’t know it’s their
155 was chipped to 200 at the shaft and it only had a 3m onIt’s got another 100hp?
Is that a 4m combi and a 3m front press?Giving the but in the middle a whirl
Yeah it's a long story but basically we got a new 3m press to run with 3m combi but things changed and we ended up with a 4m 6 months later.Is that a 4m combi and a 3m front press?
Turn the outside paddles the other way round you won’t get the ridge effectYeah it's a long story but basically we got a new 3m press to run with 3m combi but things changed and we ended up with a 4m 6 months later.
It's actually quite good you don't get the spill onto drilled ground from the paddles and the duals roll the bit that's left . A 3.5 to 3.8m would be ideal