McCman
Member
- Location
- Staffordshire
I'm assuming you have 3 powershifts on this tractor?I've got a 2016 X6.420.
When wanting to up shift gears say from 3-High to 4-Low I can only go from 3-High to 4-High and then I have to use the splitter to get down into 4-Low.
Is there any way to overcome this as the revs die off quickly when pulling a load?
If so it can be altered to make it better, there is a setting in the transmission configuration called 'gearshift memory' When it's enabled if you are in 3rd powershift and you change a range gear using the de-clutch button on the gear stick only it will always drop the powershift one gear so will always move it to 2nd which should then match your speed to change gear. If your in 1st powershift and you change a range gear it will also shift the powershift up to 2nd gear again to match the right speed.
This will only happen when using the de-clutch button on the gear stick and never on the clutch pedal.
It has to be altered by the dealer diagnostic tool but only takes 5 mins to do.