wasted years
Member
- Location
- Cumbrian born and bread
MF 80 loader for MF265
- Thread starter Thomas5060
- Start date
- Location
- Larne, Northern Ireland
Yup ballymena auction lol. Was on with Ben sargant there so hopefully he will have something
Andy044
Member
Was there anything interesting at the auction?
I didn't have time to go.
- Location
- Larne, Northern Ireland
I couldn't tell you Andrew, I was only there to lift the loader, although granda did say there was some better stuff at it, not the same amount of scrap as usual
multi power
Member
- Location
- pembrokeshire
Where is the auction in Ballymena?
- Location
- Larne, Northern Ireland
multi power
Member
- Location
- pembrokeshire
Since when has there been a livestock market ? I can't even remember where the Woodside road is, I remember when the market was at the fair hill, but that's before your time
- Location
- Larne, Northern Ireland
It's been up about 10 years or so, the ballyclare market shut down and relocated to ballymena. There's still a market at fair hill on a Saturday morning but it's like fruit and veg and a car boot sale
Edit, it's not at fairhill, it's behind cinema but I forget what you call it
Boohoo
Member
- Location
- Newtownabbey
Woodside road is where Moore concrete is if that's any help? Market is on the other side of the road from Moore, it's behind Michelin
- Location
- Larne, Northern Ireland
So got this for £100, not in best of shape but between the two loaders hopefully make one good one
two-cylinder
Member
- Location
- Cambridge
- Location
- Sorn Ayrshire
See where the front bracket bolts onto the side frames you will need to shift it to the rear holes ,, the front ones are for a 188 or 590. hopefully the rest of it will be straightforward
- Location
- Larne, Northern Ireland
Aw dear so it ain't right either?See where the front bracket bolts onto the side frames you will need to shift it to the rear holes ,, the front ones are for a 188 or 590. hopefully the rest of it will be straightforward
two-cylinder
Member
- Location
- Cambridge
Check for cracks around the hollow tubes at the front of the loader and the crowd ram chassis mounts.
Much easier to weld before fitting
Much easier to weld before fitting
- Location
- Sorn Ayrshire
No No dont panicAw dear so it ain't right either?
just a case of bolting it in the other holes
multi power
Member
- Location
- pembrokeshire
I can barely remember the Michelin factory, let alone how to get there, I must have a look at a map one night ,
wasted years
Member
- Location
- Cumbrian born and bread
Bet that's entertaining with worn track rod ends and that shaft that wears out in the middle of steering linkage.265 Multipower on oversize tyres.
Good for over 20 MPH
Boohoo
Member
- Location
- Newtownabbey
It's on the main road from Ballymena to Broughshane
two-cylinder
Member
- Location
- Cambridge
You are assuming too much,when greased regularly wear is minimal.