Search results

  1. C

    Merlo P33 7

    The Fuse is located inside the engine compartment. Open the engine cover and the fuse is located to the top right behind the Transmission Header Tank .
  2. C

    Merlo P33 7

    I checked the Fuse and it was a Faulty connection at the Fuse Holder. Thank you very much for your help.
  3. C

    Merlo P33 7

    its 20 yrs old. Thank you for replying. I will check the engine bay
  4. C

    Merlo P33 7

    Hi, thank you for replying, where about is the switch located. I've not had the machine long
  5. C

    Merlo P33 7

    Good afternoon, can anyone help? My Merlo electrical system is completely dead. It will not start, lights etc do not work either. I have checked the battery and it is fully charged and in good order. The Fuses behind the Dash are all ok. Are there any other Fuses anywhere on the...
  6. C

    Samson Muck Spreader

    Thank you.
  7. C

    Samson Muck Spreader

    Good evening could anyone give advice on how to join the floor chains of a Samson Spreader. The chains are the flat type which link into each other. I have slackened off the nuts on the Tension Rods but they appear to be held tight by hydraulic rams. How do I release the pressure on the...
  8. C

    Claas Dominator 85 Retromat Drive

    Thank you to everyone who replied. I used one of the Brake Master Cylinders as DrWazzock suggested to replace the Clutch Master Cylinder. Clutch is working fine now
  9. C

    Claas Dominator 85 Retromat Drive

    Good evening, can anyone help. I urgently need a Clutch master Cylinder for this machine, does anyone know where I could get one. Dealers don't seem to have this in stock due to the age of the machine. Thank you
  10. C

    Case 4210

    It's the one with low, high and reverse
  11. C

    Case 4210

    Thats great, thank you for taking the time to reply
  12. C

    Case 4210

    Good evening, just looking for a bit of advice here. I have a Case 4210 with manual forward and reverse Shuttle. Can I tow start this Tractor?
  13. C

    Matbro TR250 engine cutting out

    Thank you for all the help.
  14. C

    Matbro TR250 engine cutting out

    Its a TR250ITL
  15. C

    Matbro TR250 engine cutting out

    Not as far as I can see, sometimes if I keep the machine revving for a few minutes it will move?
  16. C

    Matbro TR250 engine cutting out

    Thank you I will give that a try
  17. C

    Matbro TR250 engine cutting out

    Cutting out as if the key was switched off
  18. C

    Matbro TR250 engine cutting out

    Good evening Just wondering if anyone can help. My Matbro TR250 engine keeps cutting out when I put the Shuttle Lever in forward and the same in reverse. I have checked all the fluid levels which are all satisfactory. Has anyone any suggestions as to what to try next. Thank you
  19. C

    John Deere 568 Baler

    Good afternoon, I am looking at buying a JD 568 Baler, would anyone be able to tell me what these Balers are like and what to look out for. I would be Baling Silage and Hay mainly. Thank you.
  20. C

    Matbro TR270 Problem

    Thank you to everyone who replied. I had accidentally moved the switch when I was removing the Joystick. Machine is back up and running now.
Top