Search results

This was correct. Cheers it got me sorted. Dealer had then in stock

I have a taarup Straw blower. This u bolt has broke. It's for the floor chains. Is this a standard thing one can buy in a hardware shop or is it a genuine piece only? Anyone hardly have the part number?

Have a taarup 832 straw chopper. Need a new hydraulic ram for the shoot on the swivel blower.ram is to direct the shoot higher and lower. It's a small ram. Genuine part is mega money. Where could I get a spurious? Dealer was saying its 40 bore and 120 stroke if that makes sense?

Oil was changed a year ago but wouldn't have 30 hours done since. 15w40 engine oil was used.

So got a new manuka oil pressure gauge put into my hitatchi digger today. The one with capillary tube. Is has an Isuzu 4bd1 turbo engine in it. It read the following pressures. At start up it was about 40 psi. Then worked it for an hour to get it hot. When left idling at working temperature it...

Where is this on the engine? A lot of sensors have been disconnected on this engine already in a previous life.

Have an isuzu 4bd1 turbo in my hitatchi digger. Is anyone here familiar with it? Where can I plug in an oil pressure gauge to get the psi it's working at? There are these little squares in it. I can hardly plug into them?

https://klr.com.au/store/land-rover/perentie-and-110/engine-isuzu-4bd1/oil-system-and-filters/spin-on-oil-filter-housing-4bd1/ The sensor coming out the bottom of the housing - what would that be telling? Oil pressure or oil temperature?

Is there any good air freshers/cleaners you can buy to give the cab a nice clean fresh smell as if it has just been valeted. Not a rotten magic tree type thing that u hang from the mirror but something you spray and wipe around the place? Are those grassmen chrome products any good?

Do you mind me asking how much? Saw one in my dealer but I was afraid to ask since it said new holland on it

Is it much if a job to install all the wiring for indicators into a machine from scratch? Have an old vintage tractor and all the wiring and indicators have been taken off it years ago. Wondering would it be a big job to redo all the wiring and switches for the indicators all from scratch

Price kleber too. They usually have some type of offer for cash back

Is the front part near the radiator side or the other side?

I'm trying to find the engine number on an Isuzu 4bd1 engine Would this be the number? There doesn't seem. To be a plate anywhere in the engine

A bearing sounds unusual to have in there?

It's the pin below the two rams in the centre that seems to have some wear in it. Is there a pin and bushing in this or what?

Damn the file is too big to upload as its a video I took. It's basically the king pin I think in the back of it.

What is worn in this massey 860 backhoe for this to move back and forward. The rest of the machine has had new pins and bushings everywhere and this seems to be the only place with a bit of wear.

Old Hitachi digger here. It has a 4 cylinder turbo Isuzu 4bd1t engine in it. The engine is gone in it. I have access to a very good Isuzu 6bb1 straight engine for more or less free. Would this engine ever bolt on or will it be totally different?

What's the best way to clean out a pan mixer afterwards? Power washer? Do you need to get them spotless after every wash?