One of the two bearings on our jones mk10 fell apart and needs replaced. does anyone have any tips for removal please? Ive taken off the chain on the outside and slackened the two bearing houses. Do i need to take off the cogs on both sides? seems like an impossible task, the outside one...
So the engine seems to be breathing a lot less now than before the oil change which is good. However there seems to be more oil coming out the rocker vent pipe than before. When I cleaned the pipe a long spring came out of it. I havent put the spring back in yet, would this have anything to do...
So i checked the vent pipe and it's clear. Changed oil and warmed the engine for a good bit and still breathing but not just as bad. Is there anything else I should check before getting a compression check done? I had a DB before which had broken piston rings and it was an awful pig to start...
Sorry should have said that was also on the to do list. Apparently it was just changed before i bought it but who knows.
Picked up a filter and oil yesterday. The guy looked up the model and said Exol 15W/40 was correct.
Hi all, I have a MF 360 which starts on the first tip of the key and has plenty of power and does not smoke from the exhaust. Bought it from a potato farmer and looks and drives like it never had a hard life. Ever since i took it on its first hard haul it has started to breath heavy when warm...
Hi, thinking of buying a kawasaki kvf 360. 2010 with very low hours, very clean and drives well. Has anyone any experience of these quads good or bad? cheers
Hi, anyone on here own or have experience of a MF 360? Only needed for a small holding, mowing and square baling in the summer and general yard duties. Would it be fit to lift a round bale? Would it be wiser going for the 4 cylinder 362 rather than the 3 cylinder turbo engine thats in the 360...
No response in the arms, he says he shook hay in the summer and they started to slow up a bit but he reckons he can get it sorted. I think he's being optimistic.
The steering was terrible, felt like there was no assistance whatsoever and the wander across the road was shocking.
It also...
So i went to see a 250 (actually a 20e painted over) and it was pretty rough. The hydraulics and pto werent working and the steering was heavy with lots of play. Is there much to go wrong with the hydraulics, the owner reckoned it was a handy clean of the filter? And would it take much to...
I would say 4wd wouldn't help a 47hp tractor but it must be handy all the same. Most opinions seem to be that they are under powered but anything bigger like a 360 or 362 are serious money.
msheep66 I'm going to view one this week in the hope of buying and just trying to get as much information as possible. Looking for an upgrade on the 135 for a small holding and fancied a more comfortable cab and power steering and the heavier backend would also be useful!
What sort of mph do...
Hi, changing the rear wheels on a massey 135. They are currently 12.4 x 28 and I was hoping to change up a size to 13.6 or 14.9 for a bit more width on wet ground. Does anyone have any experience of doing something similar?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.