Search results

Ploughing today and hit a big stone and bent auto reset ram thing. Will it be OK of its straightened . Massey plough same as overum. Think pressure must be a bit too high, but can't find any guide of what to set it at.

Maybe 12 years ago it was insulated with those polystyrene sheets held up with wooden lathes but now the birds have it wrecked. Would spray foam be as attractive to the birds? Or is there anything else that would do the job? The birds even have pulled out the rubber things that sit between the...

Puzzled as to which topic this should be but I suppose its a machine of sorts. Have a problem with my phone data. Every month it works perfectly until the 13th of the month, then data will not work until the 1st of the next month. Provider says its the mast getting repaired? I replied that I...

Have a problem with a gate valve sticking with a teaspoon full of silage, then the tanker can't fill because it is drawing air through it. Happens about 3 times a day. Why does the manual valve that I fill through never stick, but the hydraulic one is a torture

Page was slow to load and I tapped on something which opened something else then a message came up about unignoring someone, but it didn't stay open long enough to see who I have ignored, any way of finding out?

As above

Since my phone updated (I think) I can't reply properly to a post. It always ends up merged with the post, instead of below it. What's up?

Any ideas for who to get a set of boards off?

Which are any good? Don't want 50 pockets, want stretchy waist, splash proof, not ones that rise up out of wellies.

Anyone got one they don't want? Preferably a fold up, no pto needed.

Tm 140, lift was perfect last week, will do nothing today, no error codes, nothing on the dash at all where it should tell you the height, fuses all ok, what do I try next? Any ideas,

What's reliable and easy started, it's just to use to feed with in the summer so that the loader tractor isn't tied up and can go to other jobs easier. I know old matbro teleram 3 are old but would they still do a turn or better going never and paying finance on a jcb 310 or similar

Just being nosy but my sister in France sent me this picture and I'm curious as to what's growing.

Anyone on here sell such a thing? Tried marketplace and it helpfully brought up a magazine

I've tried bedtilling deep, shallow, slow, fast, tried back of destoner up, down and somewhere in between, still won't take it in. Was OK in the last field, what next?

Anyone know if this business is still going? Have sent numerous emails, left messages and text but no answer, I'm wanting to buy either a potato brusher or washer.

Just asking on the off chance, would anyone have 36 and 42 mm Web drives? Just thought I'd ask before ordering new ones in case someone has sold their machine and has a heap of parts

Asking for a uncle, what to replace it with? He dislikes having to put a pickup into 4wd to pull a trailer out the end of the road then try and get out of 4wd again, he likes the fact that the old discovery holds nearly a ton of meal and it's dry and low for throwing it in and pulling it out

Anyone going? Have to make my mind up tomorrow

Better to have one perched up on a gantry or one lower down with an auger? At the minute the meal is tying up half a shed that I could be doing with. Only problem is that my last bin didn't run very well but I'm told that they should be in the sun instead of in a dark damp place to stop...