Change of plan now. Driving to Groundswell from Luton on Wednesday morning as before but now most likely going to London on Thursday evening/Friday so won’t be returning to airport after the conference.
Looking for 48" rear discharge grass cutting deck for Iseki SGR19 ride on mower. Deck model is SCM48. According to Iseki, they have been out of production for several years now. Anyone have a good used one for sale or know of new old stock in a store somewhere? This model Iseki was also sold in...
Yes, I think you’re approach is best. I assume you’re not using a PCB then? I think a lot of the noise users are experiencing may be due to the PCB setup where components are so close together. What version of AgopenGPS are you running?
Much of the need for dual antenna can be avoided if you place the inclinometer over the gearbox. Even without cab suspension, the cab vibrates too much and impacts the roll measurements - also when it is placed on the cab roof, this effect is multiplied the higher it is.
I'm considering going down the AgOpenGPS route and using a similar receiver setup. Some people prefer the Digikey version of the F9P (for reason that I now can't remember). What are you using for inclinometer, compass, etc?
I use an Eijkelkamp Penetrologger (https://en.eijkelkamp.com/products/field-measurement-equipment/penetrologger-set-a.html) for my fieldwork. It takes a reading every 10mm to 80mm soil depth, or until hit a stone! The digital screen is great for showing the resistance throughout the profile and...
Great Webinar. I will definitely be doing better research before buying next set of tyres. I know it's important to take tyre pressure when tyres are cold, but I wonder what correction factor the vario pressure systems use before reinflating for road use.
Anyone find a supplier of 3 piece baker boots for s tines? Much difference in overall performance between using the angled s tines or the coil tines on duncan/aitchison? Either one better for not pulling up stones? S tines are cheaper to buy than coil tines anyway.
Willing to import but ideally within Europe - might get cost prohibitive importing from further away. What do you suggest? Have you some links for me to research?
What double disc assemblies are available for building my own no-till drill? Weaving have two types they sell. What about Bourgault or what other ones are available. Am handy at fabricating if was given some inspiration on how to make my own?
Heard that happening to a friends before. Main dealer out good few times and couldn’t sort. Local ford mechanic sorted in 5mins. Was a little spring somewhere to do with clutch or a switch if remember right.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.