Wanted!
I am looking for a "cylinder head gasket" and "inlet/exhaust valve set" for my old Ford 1200 Compact Utility tractor, Shibaura built between 1979 - 1982.
I made this purchase recently for my off grid croft, thinking a simple rebuild would have it up and running in no time, until I...
Hi Folks,
I have a 2000 6910 with almost 11k hours, as far as I'm aware.
Have recently restored it along with new head gasket, a rear half shaft seal and complete service.
Everything seems to be going ok until it heats up after an hour or so of work.
When it is heated up and I bring to a...
1994 Cummins 6T-590/92. Weeping water externally cyl one above water pump area.
Use OEM gasket? Checking for distortion? Always skim head? OR, just re-torque bolts and check?
I need the torque numbers, ideally a manual. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.