531 70 JCB TELEHANDLER FAULT CODES

[Pie face]

Just started her up and two codes pop up, looked in the book can't see anything, checked JCB online code finder and they ain't listed. Need to crack on does anyone know what they could be? Don't want to stop if possible.


Code 1 : P2135-FA
Code 2 : P160D-00

 

[Fraserb]

Just started her up and two codes pop up, looked in the book can't see anything, checked JCB online code finder and they ain't listed. Need to crack on does anyone know what they could be? Don't want to stop if possible.


Code 1 : P2135-FA
Code 2 : P160D-00

More than likely no help to you but I tried them without the letters and the first one relates to voltage issue with foot throttle and second one a functional safety fault.

 

[gpikcil]

P2135-FA Foot Pedal Correlation error (track 1 over track 2)
P160D-00 Foot pedal signal fault (ESM)

1.	Disconnect the sensor.

2.	Switch the ignition ON.

3.	Check supply voltage is 5 volts (pins 1 and 4). Connector pin 3 and 6 should read ground (0 volts).

4.	If voltages are incorrect, check harness for continuity and ground conditions, check ECU pins for evidence of contamination or corrosion.

5.	Measure signal voltage from the throttle position sensor when the throttle is at idle.

a)	Pin 2 = 0.9 to 1.1 volts.

b)	Pin 5 = 0.4 to 0.6 volts.

6.	Measure signal voltage when throttle is fully depressed.

a)	Pin 2 - 4.4 to 4.6 volts.

b)	Pin 5 - 2.15 to 2.35 volts.

 

[Pie face]

Thanks guys, I've managed to clear it by turning the battery master switch off, going off and having a cup of tea then turning it back on again, hope that's the end of it!

 

[Pie face]

It's started doing it again and now no amount of switching it on and off works!

I've checked with a multimeter and got the following results (in red) as per gpikcil's advice and found two of the readings slightly out of the range. Would this be enough to cause the error, if yes does it point to the pedal sensor?

P2135-FA Foot Pedal Correlation error (track 1 over track 2)
P160D-00 Foot pedal signal fault (ESM)

1.	Disconnect the sensor.

2.	Switch the ignition ON.

3.	Check supply voltage is 5 volts (pins 1 and 4). Connector pin 3 and 6 should read ground (0 volts). ALL CORRECT

4.	If voltages are incorrect, check harness for continuity and ground conditions, check ECU pins for evidence of contamination or corrosion.

5.	Measure signal voltage from the throttle position sensor when the throttle is at idle.

a)	Pin 2 = 0.9 to 1.1 volts. 1.05V

b)	Pin 5 = 0.4 to 0.6 volts. 0.8V

6.	Measure signal voltage when throttle is fully depressed.

a)	Pin 2 - 4.4 to 4.6 volts. 4.57V

b)	Pin 5 - 2.15 to 2.35 volts. 2.47V

 

[robert1]

i have an error code b1542-68 coming on and i seem to be losing power,what would it be?

 

[Faisal]

I have a fault code on secreen is d014 kindly support what's issue