Would that be because I had the screen resting in the steering wheel and antenna resting on the armrest?Perfect for connectivity, but what's with that -176 angle?
Would that be because I had the screen resting in the steering wheel and antenna resting on the armrest?Perfect for connectivity, but what's with that -176 angle?
That's steering angle... top number is "where autosteer should be steering", bottom is "where you are currently pointing". So either your wheel angle sensor has serious issues, or your CPD is way off.Would that be because I had the screen resting in the steering wheel and antenna resting on the armrest?
Hmmm, all I’ve done is plug in the pcb, antenna to the toughbook , theres no wheel angle sensor connected anywhere,That's steering angle... top number is "where autosteer should be steering", bottom is "where you are currently pointing". So either your wheel angle sensor has serious issues, or your CPD is way off.
If no WAS, don't worry about it then - the lack of reading would explain it.Hmmm, all I’ve done is plug in the pcb, antenna to the toughbook , theres no wheel angle sensor connected anywhere,
maybe I’ve changed a setting accidentally in simulator mode?
Yes, change in the 3-bar menu at top leftIs it possible to change the path where it looks for fields from the documents folder? I'd like it to point it at Google drive to work at a desktop and multiple tablets without thinking about it.
I expect some discipline would be required to manage the risk of opening the same field on multiple devices.
Click on this iconTry the switch with the cogs and up address, go in and click udp until it turns green.
Just watch the video, shows the whole processHaving problem getting a fz g1 to work, i have the first one set up and working ok but 2nd one doesnt want to play ball. Have changed network adapter settings with correct ip address etc, ethernet connected, any help appreciated as its likely something obvious
Yes!! Obviously didnt click several times at once cos then it went green. Have done this many times clicking once and nothing happened.Try the switch with the cogs and up address, go in and click udp until it turns green.
Had 5 mins to look at this again today - I might be being thick but when in the configurator as shown in the video, nothing comes up in either the teensy or serial ports box, so I can’t flash the firmware.Follow this - no COM ports needed
The config tool works over USB, not ethernet. Plug the Teensy into the tablet (remove from PCB) and do the same with F9P.Had 5 mins to look at this again today - I might be being thick but when in the configurator as shown in the video, nothing comes up in either the teensy or serial ports box, so I can’t flash the firmware.
I’ve connected the all in one PCB via Ethernet cable, could this be something to do with it?
Pumas windows would be too curved for a suction to stay on with weight if a Panasonic all day. You can get the little bracket to mount screens on for them only £75 from a dealerWhich RAM mounts are people using for the Panasonic CF-D1 tough book?
Would have preferred to not use a window suction mount for the fear of it falling but the Puma is pretty lacking in places to mount a bracket .
Struggling to find anything online .Pumas windows would be too curved for a suction to stay on with weight if a Panasonic all day. You can get the little bracket to mount screens on for them only £75 from a dealer
The CF-D1s are quite heavy and bulky so not many off the shelf mounts fit.Struggling to find anything online .
Struggling to find anything online .