Case 4240 Hi lo help please

[Paul farrier]

Hi doing hi lo unit have split tractor
How do you get bottom shaft back to remove gear which allows hi lo to be pulled forward

 

[Richard Devon]

Take the MFD box off, look upwards and you will see a PTO pack with an off centre roll pin holding it to the shaft, drive it out. (When you reinstall make sure you get it right, it will only go on in one place)
Go round the back undo the bolts holding the 1000rpm shaft in and withdraw the shaft, pack will fall out.
Inside the bellhousing take the cover off the bottom shaft, remove the snapring on the shaft, drive the shaft backwards, gear will fall off

 

[Paul farrier]

Take the MFD box off, look upwards and you will see a PTO pack with an off centre roll pin holding it to the shaft, drive it out. (When you reinstall make sure you get it right, it will only go on in one place)
Go round the back undo the bolts holding the 1000rpm shaft in and withdraw the shaft, pack will fall out.
Inside the bellhousing take the cover off the bottom shaft, remove the snapring on the shaft, drive the shaft backwards, gear will fall off

As in the PTO clutch pack will fall out
Thanks Richard

 

[Richard Devon]

As in the PTO clutch pack will fall out
Thanks Richard

Yes, its a bit of a two-handed job.....either get someone at the back to withdraw the PTO shaft while you hold the PTO pack......or if you get yourself under the tractor with your back against the left rear wheel and you got long arms you can do it yourself.....but the pack is q heavy