Cement mixer pto to hydraulic drive

[Shovelhands]

Good to have you back @Mr Happy

 

[young&keen]

Firstly thanks to @Chrisf and @Shovelhands for sorting my technical issues.
Right back to hydraulic cement mixers motors. I would use the Danfoss OMR100 motor as you will achieve the 270rpm with the 30lpm being supplied by the tele handler. If you do decide to direct drive the mixer barrel you would be well advised to use the Danfoss OMS series of motors as it is able to deliver more torque but you will require more flow.

Thank you very much, just to clarify the motor will run a small cog with chain drive onto big cog on drum,so I take it the danfoss omr 100 will do the job?

 

[Mr Happy]

Thank you very much, just to clarify the motor will run a small cog with chain drive onto big cog on drum,so I take it the danfoss omr 100 will do the job?

With thebingo that has been posted a Danfoss OMR100 will be ok. If the motor is going to be subjected to any side load the OMS100 will be a better motor because it has two bearing supporting the drive shaft.