Combine knife

[Bramble]

Snapped mine this evening, will get a new one in the morning, but can I weld the old one up to keep as a spare or will welding completely knacker it?

 

[Lincs Lass]

Its only a length of flat bar ,aslong as you dont cut anything out else you will loose a tooth fixing point ,V it out ,butt it together and glue it up ,,you've nothing to loose as its already broken

 

[Stock]

I welded many a finger bar ones when I had a full head of hair and all me teeth..........................................

 

[Exfarmer]

I have welded several, but they often snap because of other problems. Make sure you cure the problem before putting the new one in.

 

[melted welly]

Welded ours loads, does for a spare. Kept snapping at the drive end so we weld the broken bit(s) on the other end. Think the metal can get tired over time.

 

[Adeptandy]

Did mine and it lasted for years, v out and weld, then weld the knife section to the next one ( mine had broken at a bolt hole ) then as it was close to the knife drive I welded the knife section along the back as well. Figured if the welded section broke I'd just run a bit wide for the rest of the day