Hi,
In the doc for VarioGuide it says that the Isobus-feature is available in the 300-series - but the SectionControl (fendt wording) is not. Does that mean that if i have implements that support Isobus (say a vederstad drill), i cannot actually control the section of that drill through the 300-series? Confused as one of the Isobus standards is ts-sc (section control).
In the doc for VarioGuide it says that the Isobus-feature is available in the 300-series - but the SectionControl (fendt wording) is not. Does that mean that if i have implements that support Isobus (say a vederstad drill), i cannot actually control the section of that drill through the 300-series? Confused as one of the Isobus standards is ts-sc (section control).
