Finishing Share

[Ford4610]

What would be the best shape for a finishing share. I want to make one to stop loose earth falling into the furrow bottom.

 

[Mydexta]

What would be the best shape for a finishing share. I want to make one to stop loose earth falling into the furrow bottom.

What bodies are you using??

 

[Mydexta]

This is one my pal uses to suit tcn bodies

 

[Ford4610]

What bodies are you using??

Hydrein

 

[Ley253]

Hydrein

Super, or the earlier basic bodies? If super, the normal share will leave a clean furrow, the usual culprit responsible for loose soil is the disk, you do need a left hand version

 

[Ford4610]

Super, or the earlier basic bodies? If super, the normal share will leave a clean furrow, the usual culprit responsible for loose soil is the disk, you do need a left hand version

Super with top extensions. Have a left hand disc. Loose on disc shank stem. The hub is slightly further behind share point compared to original disc.

 

[Ley253]

should be no real problem then perhaps it needs setting a little wider. If you can take the plough down to 11" for the finish, that can help, or perhaps push the rear board out a little on the show furrow, to leave a little more room on the return run.

 

[Mikeysuds]

Sorry to jump in but on the same topic , opening and finishing share for YL 183 ? any pics guys wha you use ?

 

[Fergie Ploughman]

never really had any joy with finishing shares in vintage (YL183's), tried a couple of ideas and found the std YL44 does just as good a job....be interested in others views though!!

 

[Pennine Ploughing]

on a YL, with a 44, if it's cut out right, no need for any bits welded on,