Fire damage

[glasshouse]

will this repair?
Its had a toasting?

 

[Mr Happy]

In a word NO!

 

[Phil P]

will this repair?
Its had a toasting?

If the spools move free in the block it may be ok, new seals and couplers etc.
If the spools are tight it’s fubar.

 

[Dog&stick]

Done one a few years ago, I'd say you be ok, new couplings,check centring springs. when you remove input/ output ul see by "0"rings how hot it' got. I remember the cable lock blocks are not cheap.
The rams that were on the loader, looked ok, but didn't reseal, ( had gone oval with heat). Properly cheaper than valve block

 

[glasshouse]

Thanks, it hasnt been that hot i think, just hoses burnt off.
Will try to open it tomorrow

 

[Dog&stick]

Very little in there, looks like load sensing block? , remove spool caps, check springs, o rings, under caps.where cables go In clamps , there should be snap rings, keep hold of them, don't come with the new cables.

 

[davedb]

Just make sure the spools slide free and renew the o rings at either end, check the springs and caps you’ve nothing to loose so try it