Fusion 2 help

[nosmokenopoke]

Periodically when changing the wrap. Get the first spool changed ok. poke the button to give the wrapper A half turn to change the other spool. The wrapper sometimes does a full turn, Instead of just a half turn. Any ideas? Thanks

 

[valtraman]

On my fusion 3 which is same I think my wrapper went round a full turn as well I put it down to holding buttons in too long

 

[Fendt516profi]

Soon as it sets off you should let go of button

 

[Southmec32]

One of the dispensers are two far from the sensor and need adjusting by moving dispenser on the slotted holes where it bolts to the ring

 

[Fendt516profi]

One of the dispensers are two far from the sensor and need adjusting by moving dispenser on the slotted holes where it bolts to the ring

Would that not show up when it was wrapping to either not registering that spool and saying the film was broken or putting two much wrap on cause it only registers one spool going round so slows down to do the bale with one spool

 

[nosmokenopoke]

One of the dispensers are two far from the sensor and need adjusting by moving dispenser on the slotted holes where it bolts to the ring

Thanks very much. I’ll try this

 

[Wellytrack]

Do you have both magnets present on the bottom ring wheel?

 

[nosmokenopoke]

Do you have both magnets present on the bottom ring wheel?

Where do I look for these?

 

[Wellytrack]

Where do I look for these?

On the back facing the baler frame.