Today I had a look at my latest purschase - a used Horsch Terrano 3 FX. Even though it is a very simple design I still have one question for other Terrano users, it is about the depth settings...
My Terrano has manual depth settings, in other words I manually put clips on the connector rod between the frame and the packer. Since I am going to run the Terrano quite deep, the packer will hang in the air when I deattach it from the tractor if I do not change the clips from "working position".
Is it ok to completely remove the clips from the back side and not putting them on in the front side... In other words having the packer in a "float" mode until it hits the right depth?
My Terrano has manual depth settings, in other words I manually put clips on the connector rod between the frame and the packer. Since I am going to run the Terrano quite deep, the packer will hang in the air when I deattach it from the tractor if I do not change the clips from "working position".
Is it ok to completely remove the clips from the back side and not putting them on in the front side... In other words having the packer in a "float" mode until it hits the right depth?