johnflimston
Member
- Location
- Glamorgan, Wales
Got a problem with wrapping table on baler wrapper.
Massage coming up says wrapping table wont move, check hydraulics and sensors. Found an oil leak on block behind manual controls but that was on baler door circuit, o ring change sorted that but still having fault with table.
It works fine with manual handle but wont cycle automatically.
Any ideas?
Massage coming up says wrapping table wont move, check hydraulics and sensors. Found an oil leak on block behind manual controls but that was on baler door circuit, o ring change sorted that but still having fault with table.
It works fine with manual handle but wont cycle automatically.
Any ideas?
