it's not over
Member
- Location
- thunder rd co.antrim
Best fun you can have with a 24 year old
Best fun you can have with a 24 year oldView attachment 803634
Smash the outer with a hammer, make sure you have gloves and goggles on. Then grind the centre till you’re just about to the shaft and then split the last bit with a chiselWhat the best way to get these bearings offView attachment 814912
Three leg puller and then replace the seal housing and seal because you will damage it in the processWhat the best way to get these bearings offView attachment 814912
I always have tried to save the seal part as it costs more than the bearing and I have s/h one if needed but I have removed them with a puller with two legs and saved both.Smash the outer with a hammer, make sure you have gloves and goggles on. Then grind the centre till you’re just about to the shaft and then split the last bit with a chisel
I'll get a picture. It's the spring for putting tension on the feed rollers