Kuhn 30.1 electric to manual

[Bealy]

Has anyone converted an a 30.1 spreader with electric actuators to hydraulic rams or know what parts I need?

Thanks

 

[Jsmith2211]

why would you want to do that?

 

[Bealy]

why would you want to do that?

Got a wiring fault at the moment that I can't get to the bottom of, replaced two actuators before and had them apart countless times..

 

[Mr Charisma]

why would you want to do that?

First thing I would do
35 thousand acres and no down time bar one hyd hose which only lost me a couple of hours

 

[Always wandering]

What is fault linak or rohmheld actautors?

 

[Bealy]

What is fault linak or rohmheld actautors?

They're the linak actuators, seems to be signal problem this time though, one actuator works but if you switch the plugs the other side works..

 

[Always wandering]

Not much wiring to them looms are pretty bullet proof unless damaged by top link etc have you cleaned plug into box with emery paper ? If you check set points in test diagnosis page do both actuators work

 

[Bealy]

Not much wiring to them looms are pretty bullet proof unless damaged by top link etc have you cleaned plug into box with emery paper ? If you check set points in test diagnosis page do both actuators work

Aye cable has been damaged before, a few of the wires were corruded all the way to the black box on the spreader. Ended up running switch direct to the actuator motors just to get me going.

 

[Always wandering]

Aye cable has been damaged before, a few of the wires were corruded all the way to the black box on the spreader. Ended up running switch direct to the actuator motors just to get me going.