Kv plough expert

[glasshouse]

Needed, plough wont turn over

 

[Boomerang]

Needed, plough wont turn over

your going to have to give more to go on , could be any number of things .
could be something daft ,pipes in wrong, one pipe in one spool, other in different spool.pipes in wrong way round , pipe not actually in properly , oil flow ? is it manual or electric spools if electric have you set flow rates and timing properly .even dafter, are you operating the spool the pipes are in .
pictures of plumbing will help.
but you havnt really given enough to go on .

 

[glasshouse]

your going to have to give more to go on , could be any number of things .
could be something daft ,pipes in wrong, one pipe in one spool, other in different spool.pipes in wrong way round , pipe not actually in properly , oil flow ? is it manual or electric spools if electric have you set flow rates and timing properly .even dafter, are you operating the spool the pipes are in .
pictures of plumbing will help.
but you havnt really given enough to go on .

Ok, now i am sat down
Electric spools
Ed85 5 furrow plough
It reaches tdc but wont go over unless one wheel is in a fair hole.
Valve block already renewed
Hoses ok

 

[Lewis821]

Try turning oil flow down ?‍

 

[michael N123]

Try plugging into a different spool

 

[glasshouse]

Try plugging into a different spool

Done that

 

[KB6930]

There's a restrictor in one of the pipes at the top of the ram (200 headstock) take it out and see what happens it's a 3/8 - 3/8 fitting

 

[Speedstar]

Needed, plough wont turn over

Is it just one way turning giving you the problem ?
Or both ways ?

 

[ploughman1963]

plenty of grease in the turnover shaft bearings is essential - doesnt take much to cause a problem

 

[Flat 10]

Put new male QF probes on?

 

[glasshouse]

Is it just one way turning giving you the problem ?
Or both ways ?

It was only one way till i started fiddling with it, now it wont go either way

 

[glasshouse]

Put new male QF probes on?

Done that

 

[glasshouse]

There's a restrictor in one of the pipes at the top of the ram (200 headstock) take it out and see what happens it's a 3/8 - 3/8 fitting

Turnover ram?

 

[KB6930]

Turnover ram?

Yeah depending on what headstock you have tho

 

[glasshouse]

Yeah depending on what headstock you have tho

160 i think

 

[KB6930]

160 i think

Ram up the back of the headstock or lying horizontal across the front ?

 

[Jimbo]

Does it go half way then stop in middle ?

 

[glasshouse]

Ram up the back of the headstock or lying horizontal across the front ?

Across front

 

[glasshouse]

Does it go half way then stop in middle ?

Yes tdc

 

[Jimbo]

Try turning plough over half way then quickly pushing spool the other way and see if that turns it right over