Lamborghini

[williamtomharry105]

Hi all does anyone know how to take half shaft out of Lamborghini 105 tractor so I can change the seals. Thanks

 

[njneer]

Assuming it’s the rear axle you mean.
Drain oil,down, remove complete axle trumpet Stand on its hub end.
remove lock tab in centre, undo bolt on centre of epicyclic, lift out epicyclic unit Check for shims under it for bearing pre load.
shaft will need knocked out of the inner bearing and out of the trumpet , oil seal replaced on inside of trumpet housing then the outer bearing will need removed to replace the outer seal. Best to have two new bearings to fit and you will need to check And adjust the bearing preload when reassembling.

 

[williamtomharry105]

Ok, sounds a big job then, thanks very much