Loader joystick

[vulcan]

Wondering if any one has any good ideas on how's best to stick the top back on this loader joystick?supper glue be the simplest but screw things up if ever need in the top of the joystick.

 

[milkloss]

I'd use warm insulation tape Pulled tight around the seam.

 

[AftonShepherd]

Ours is done with insulation tape and has been for years. No matter how tidy it needs redone every six months or so.

 

[Mur Huwcun]

Build up the pins with dabs of superglue intill they’re a tight fit

 

[ED.D]

Silicone?

 

[aangus]

Silicone?

yes go with the silicone

 

[ISCO]

Insulation tape here.

 

[v8willy]

yes go with the silicone

Put some tape on the outside & then silicone fron the inside, did the tail light lens on the wife's car about 6 years ago & it still passes the MOT every year, it's near black now but still intact.

 

[Matthew Britton]

Just put a dab of silicone in each hole, work it in a couple of times and leave to set.

 

[Whitewalker]

Insulation tape cos the wires pull down and detach from the switches at some point so you’ll be in there again

 

[Nithsdale]

Change the tractor...

 

[Fendt516profi]

Change the tractor...

That's a bit o,t,t. He could just buy a new loader

 

[norse]

Wondering if any one has any good ideas on how's best to stick the top back on this loader joystick?supper glue be the simplest but screw things up if ever need in the top of the joystick.

I had one the same a few years ago,got fed up with tape becoming sticky after a while so filled the knob on the lever with silicone cleaned off the excess that squelched out and never needed to touch it again