marshall 802 belt

[devonbrion1998]

802 fan belt replacement,is this a rad out job? and can I get around the hydraulic pump drive?
or does that have to be taken apart as well
Thanks in advance

 

[Barleycorn]

We used to use Brammer belting for the JDs and Marshalls with forward-mounted pumps, saves a lot of hassle.

Not sure what size, but https://www.ebay.co.uk/itm/Brammer-...-Drive-Belt-Nut-Link-Style-Belt-/254121291285

 

[devonbrion1998]

Thanks for that sounds like a plan

 

[Exfarmer]

Yes, but dont expect them to last more than ten minutes

 

[wdah/him]

i think it was a fairly simple job, cant remeber now but rad stayed in, a cable tie was used i think. possibly a big cable tie around the rubber joint and loosen the pump move it forward and fit the belt over and feed it around the fins of the fan. long time ago, ours had a fit of beaking the key driving the pump in the coupling, then we turned down the release valve in the new spool bank.

 

[Baker9]

Put an other belt in there and cable tie it out of the way to avoid the same amount of work next time when you are in there.

 

[Barleycorn]

Yes, but dont expect them to last more than ten minutes

Had one on an old Bonser forklift and it lasted for years.

 

[devonbrion1998]

well I kinda got there, I knew it was a difficult job as I did it 5yrs ago
bolts rounded off the doughnut ect, anything that could go wrong did still it's up and running but with only 5 of the 6 bolts in I managed to cross thread one due to the rubber going all misshaped once opened, very smart idea putting a spare belt in there I will defiantly do that next time. cheers all