Massey 3095

[Pyroeis]

Hi guys,

So currently I have an ongoing issue with a 3095. She won't start, when I turn the key the abcd lights light up and go off again but when I press the clutch in to turn her over the lights don't come back on like they used to and it won't turn over at all. I've pulled the clutch switch off and checked the voltage and it is only got 10.4v. The ignition voltage supply is 12v without any issue and I believe there is a smaller orange wire attached at the ignition to the larger orange wire that is supplying the clutch switch.

I have tried to put a 12v straight to the output wire of the clutch switch and she went instantly but as soon as the key was in the 1st turn position and not in the "turnover" position. When I tried to put the new 12v supply through the clutch switch again I had the same issue that nothing happened and the lights didn't come on at all, do you guys have any suggestions on what I should try to do next? Is there somewhere that I could look at replacing the clutch switch?

 

[SuperTwo]

I've had a similar problem on a 3635, I started it by crossing the starter, then when I pressed in the clutch the autotronic woke up and everything worked as it should. I think it may have been caused by a loose connection on the starter.

 

[SuperTwo]

Also check the connections on the yellow and red wires that run from the battery to underneath your rhs step. If they are corroded weird and wonderful things will happen.