Massey Ferguson 6480 error codes

[Farmer Dan 2016]

Hi

Just wondering would anyone know what the following error codes are about T2.51 and T1.37
the tractor is a tier 2 2006 dyna 6 tractor.
It may be related to the the gear selection for A-F as the T bar isn't working gear selection for 1-4 is Ok. The selector for A-F on the steering column is also not working but the forward and back is OK.
Anyone know what might be causing it, sounds like they are all related

Thanks for taking the time to read this

Regards

Dan

 

[Darragh]

Been a while since I had a dyna6 but I had bother with clutch switches I think that t1.37 might be for that but not certain...

 

[raiderz]

T251 is Powershift Module Solenoid Valve - Open circuit
T137 is Powershift and Powershuttle Module - Slippage > 10% for more than 700ms between engine speed and intermediate speed.

Those are from the Maintenance book for a D6 6616

 

[Farmer Dan 2016]

Hi Lads

Thanks for the help.
Any idea on how I go about sorting it, is it a case of replacing the solenoid???

Dan

 

[Farmer Dan 2016]

Hi Folks

Got that problem sorted, turned out to be an electrician fault

Thanks for all the help

Regards

Dan

 

[kverneland es 80]

hi error code t 2 55 showing up on a 2012 6480 ,have no error code book and need to get it sorted

 

[jack6480]

hi error code t 2 55 showing up on a 2012 6480 ,have no error code book and need to get it sorted

Don't worry about it it's only boost sensor keep going

 

[cletracboy]

On our the diff lock switch can stick occasionally, it did it on an unfamiliar driver and he accidentally calibrated the boost sensor ( holding the switch down is part of the calibration procedure) . It was easily re-calibrated, but I was told by dealer the boost pressure sensor can get knocked off when the damper plate starts to fail so can be serious. Might be worth further investigation.

 

[RmfJ]

On our the diff lock switch can stick occasionally, it did it on an unfamiliar driver and he accidentally calibrated the boost sensor ( holding the switch down is part of the calibration procedure) . It was easily re-calibrated, but I was told by dealer the boost pressure sensor can get knocked off when the damper plate starts to fail so can be serious. Might be worth further investigation.

Usually when the damper plate is failing, when you switch the tractor off, with the last engine noise you will hear a clunk clunk noise as engine stops rotating.

 

[raiderz]

hi error code t 2 55 showing up on a 2012 6480 ,have no error code book and need to get it sorted

Ran my 6470 for over a year with that error code. Annoying tho when it pops up on the display all the time.

 

[kverneland es 80]

calibrated the lot,going ok again ,

 

[Dman2]

Hi Folks

Got that problem sorted, turned out to be an electrician fault

Thanks for all the help

Regards

Dan

Hi
Could you be more specific as to what the problem was please
Have same problem myself and fitters are struggling to find problem

Cheers