Merlo teleporter

[jonnywade6150]

hiya guys and girls,
Don't know if you lot will be able to advise on where to find a parts diagram to the front and rear axle on a merlo p26.6 evt 1998 or if anyone has one would they kindly send some pictures over.

Many thanks

 

[Tractortech]

Now Then..
Have you tried your local dealer??

 

[jonnywade6150]

I have but no luck

 

[Planttech]

Which parts of axles

 

[jonnywade6150]

Hub assembly and the axle to split from the middle front and rear
Cheers

 

[Planttech]

Hub assembly and the axle to split from the middle front and rear
Cheers

Will pm you

 

[jonnywade6150]

plant tech any idea how to remove a hub seal on the merlo? Whole hub is off with shaft. Cheers

 

[Planttech]

Which seal? The main one can be done with out removing from machine

 

[jonnywade6150]

This one the first seal you come to once removed hub plate

 

[Planttech]

No, ring of bolts. 4 grub screws in the hub bearing nut and take the nut off. And the hub drain bung and it will pull apart

 

[jonnywade6150]

Brilliant thanks mate!!!

 

[Combeland]

Hi,

I’ve got a 32.6 and I am mid way through replacing the cups on the front axle - no biggy. The brakes are very sticky as well, not an uncommon problem from what I can look up. While I am half way through the job I am thinking I should strip out the whole axle, remove the callipers and give them a good clean.

Is there anything I need to know? I assume I need to just unbolt the axle, disconnect steering ram pipes, brake pipes etc. What is the best way to disconnect the main drive coming into the front diff?

Many thanks

 

[Planttech]

Hi,

I’ve got a 32.6 and I am mid way through replacing the cups on the front axle - no biggy. The brakes are very sticky as well, not an uncommon problem from what I can look up. While I am half way through the job I am thinking I should strip out the whole axle, remove the callipers and give them a good clean.

Is there anything I need to know? I assume I need to just unbolt the axle, disconnect steering ram pipes, brake pipes etc. What is the best way to disconnect the main drive coming into the front diff?

Many thanks

That’s the hard way they will come out without removal the axle.