Niteforce
Member
- Location
- East Yorks
Anybody know how to get a 12 volt signal from linkage in down position to activate area on Trimble screen.????
Have you got a 7-pin signal socket in the cab? Not all pins are always populated, but for reference:Anybody know how to get a 12 volt signal from linkage in down position to activate area on Trimble screen.????
Have you got a round 16-position socket on right hand side of the cab, near power socket?No not got that unfortunately [emoji853]
Can you put a multimeter (reading DC volts) on pins 8 (linkage position) and pin 2 (ground) and then operate linkage to see what is returned?only got the diagnostics plug near power socket