MF 7274 CEREA

[Whistler]

Tonight the unloading auger wouldn't come out to unload. Any ideas
TIA

 

[Cowabunga]

Tonight the unloading auger wouldn't come out to unload. Any ideas
TIA

Sounds like it is on strike.

What could it be? Or better, what is it likely to be? My money is on a switch, connector, solenoid or chaffed wiring. Possibly a fuse, which might or might not be caused by a faulty example of one of the above.
Could even be a burst hydraulic pipe. Easiest to check of all that one.

 

[goldeneagle]

Tonight the unloading auger wouldn't come out to unload. Any ideas
TIA

could be the button on the joystick. think its the same button as table up and down so could possibly be swapped to fault find. It could be the solenoid for pressurising cylinder the manual should have the electrical designations for it to help identify., Have you checked the diagnostics screen on datavision to see if anything is a miss there.
Does it strain engine slightly when retracting auger (even though it is in rest position)

 

[Badshot]

As above solenoid most likely, followed by switch, but do check the fuses, and actually put a continuity meter on them to be sure they're good.
The pivot grease nipples need regular and lots of grease or it seizes up and breaks rams, and or mounts.