Dave W
Member
- Location
- chesterfield
Looking for some MF wheel weights for the wheel pictured. Think they may be in halves??
@multi power I'm looking at you!!
@multi power I'm looking at you!!
Well that's no good. I was hoping you'd be sending some on a pallet this afternoon34 inch wheels on a 300 series, I'm not familiar with the weights for them
put an IBC container on a pallet, fill with water and send it to him, little note saying fill the tyresI have got ford weights if they are any good ?
It's for a hedgecutting tractor. It's ok on the flat etc but a. It hairy at full reach. Ideally a full set. Think there should be 2 either sidehow heavy do you need them?
Will do thanksI have some here but not sure what they fit
could you measure from one hole to the next on the wheel for both the 3 hole mounting and the 4
Both the 3 and 4 holes are 13” apartI have some here but not sure what they fit
could you measure from one hole to the next on the wheel for both the 3 hole mounting and the 4
ok I will have a look,Both the 3 and 4 holes are 13” apart
Thanks. I put my name on a set yesterday which should do the job but I won’t rule out getting some moreyes I have a set here will get a pic later
Got some off 690 ??
Do you still have those wheel weights to fit a 390 also looking for some front weights if you have anyyes I have a set here will get a pic later