New holland 644

[Harvester]

The baler computer is set at 125 density but turns itself off at 115 every time.you have to switch it back on generally put net in on auto but doesn't always retract it?

 

[Abacus]

are you shor the density is on the control box I only ask because on my old 650 the density is set on one of the rams

 

[del_boy]

Think that is the height size not density.
Have you got a good power supply direct from battery

 

[Harvester]

It is showing correct voltage just not sure why it turns off at the same stage every time

 

[del_boy]

It is showing correct voltage just not sure why it turns off at the same stage every time

Is it a direct power supply to battery or through another in cab connector? It might be reading the correct voltage but maybe its not drawing enough amps so the box shuts down. If you havnt got the power supply direct to battery this is a good place to start. From memory them power leads were quite big so really needs a good power source

 

[Harvester]

Ok well I will check the connections because the back lights dim then off it goes

 

[Harvester]

Think that is the height size not density.
Have you got a good power supply direct from battery

Ok I don't know much about the machine I was just asked too see if I could sort the issue so maybe it is bale size long and short it turns off at 115 thanks for all your replies so far

 

[powerontheland]

Control box should be connected direct to the battery. 125 is the diameter not the density, thats adjusted manually at the back