New Holland 8360 cp error

[Johny]

Hello,I have a problem with tractor. When tractor stands in place he won't go forward or reverse just shows CP error but when tractor is in the move example, when you are going forward and you just pull the lever to reverse tractor go to reverse without problem. Today electrician examinate tractor and clutch pedal switch is good,forward-reverse lever is good(tried newone and works same) ,seat switch is switchovered with wire... We didn't found solution...

 

[forblue]

You need to state what type of transmission have you got if you don't know put up photos

 

[Davy]

Put the clutch pedal to the floor when taking off. If your stationary I'm not sure it'll engage drive without the clutch pedal pressed

 

[Johny]

Rangecommand 18+6 . When clutch is pressed tractor works normally but we thinks that he must work without clutch..

 

[forblue]

As davy stated you must use clutch [so called] pedal.

 

[Johny]

I will talk to my electrician next week if he find solution,if not than I will drive it with clutch... In operators manual says that tractor needs to go without clutch,clutch is only needed when you start the engine

 

[norse]

You will need to use the clutch pedal when you first set off but then it will not be needed unless you leave the seat,once the seat switch activates the handbrake warning buzzer you need to depress the clutch pedal again to move off the first time

 

[Johny]

I don't have seat switch and I don't have handbrake buzzer