NH 7060 baler netting problem

Dman2

Member
Location
Durham, UK
Hi
Had an issue with the netwrap on our 7060 baler today
It seemed as though the knife was holding onto the net after it had been cut, this was stopping it going onto the next bale each time
I was having to jump out and pull the net back a bit each time for it to work.
Any ideas please
 

robbie

Member
BASIS
You can adjust the length of the net tail that's left after cutting, if it's too long it won't feed and will stay draped over the knife.
To alter it, on the side where the net wrap mechanism is there is a linkage made out of inch flat bar. In that bar is 2 bolts and a elongated hole. Stacked the bolts move them in the elongated hole to either lengthen or shorted the link.
I can't remember which way leaves a shorter net tail but the book will tell you.
 

Will you help clear snow?

  • yes

    Votes: 68 31.6%
  • no

    Votes: 147 68.4%

The London Palladium event “BPR Seminar”

  • 12,743
  • 188
This is our next step following the London rally 🚜

BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth

Join us @LondonPalladium on the 16th for beginning of UK business fight back👍

Back
Top