PowerQuad Problem

FENDT9399

New Member
Jd 6620

Splitter gears won’t change at all. Stuck in 1. It did pre select 2 when I was changing gears once but now gone back to stuck in 1.

Tried buttons on the stick and side buttons
Was driving grand then I stopped for a minute (left it running) went to drive again and it wouldn’t work
Anything I could check Any help appreciated
 

Tractortech

Member
Location
Cumbria
Now Then..
Have you checked for error codes in the EPC?? Does the orange rocker switch feel right?? I've seen them get water/dirt in them. Are the buttons on the gear lever in good order,,,, similar problems potentially..
 

njneer

Member
Had an issue back in the day with the hitch handle lever rubbing through wires in the right rear corner panel.
Caused weird and wonderful issues with gear change.
 

Tractortech

Member
Location
Cumbria
Just repair the damaged wires and re route it... I saw similar happen years ago when an apprentice had replaced a hitch cable...
They sometimes rub wires around the rear cab pillar,,,,, now that's not so good to see..
 

njneer

Member
Yes as Above find and repair the wiring, it’s not so easy to re route as there is very little , if any, spare slack in the wiring , just get a slip of rubber and wrap and cable tie it round wires where the rub is .
 

Will you help clear snow?

  • yes

    Votes: 71 32.0%
  • no

    Votes: 151 68.0%

The London Palladium event “BPR Seminar”

  • 15,103
  • 234
This is our next step following the London rally 🚜

BPR is not just a farming issue, it affects ALL business, it removes incentive to invest for growth

Join us @LondonPalladium on the 16th for beginning of UK business fight back👍

Back
Top