clbarclay
Member
- Location
- Worcestershire
I gather that while calibrating the drill, the Artemis should drive the metering unit as if it moving at 8 km/h.
However I have found that instead it seems to either turn rather slowly or rather quickly and can change from back and forth between each calibration run. The difference is like twice the speed double the amount of seed metered out after adjusting the calibration by just 5%. Max forward speed on the current calibration is about 15 km/h.
Is this normal, because the massive change in speed makes a big difference to the calibration and I can end up chasing my tail with it?
Also it seems very insensitive to pressing the buttons and far too often it doesn't notice when you press one, needing several attempts. Some of the buttons seem a lot more lazy than others. Can the sensitivity be adjusted or is the likely to be a dodgy connection in the unit?
However I have found that instead it seems to either turn rather slowly or rather quickly and can change from back and forth between each calibration run. The difference is like twice the speed double the amount of seed metered out after adjusting the calibration by just 5%. Max forward speed on the current calibration is about 15 km/h.
Is this normal, because the massive change in speed makes a big difference to the calibration and I can end up chasing my tail with it?
Also it seems very insensitive to pressing the buttons and far too often it doesn't notice when you press one, needing several attempts. Some of the buttons seem a lot more lazy than others. Can the sensitivity be adjusted or is the likely to be a dodgy connection in the unit?
