Roof price for a 60 x 30 shed

[atlas]

What would a ball park price be for a fibre cement roof and z purlins for a 60ft x 30 ft building 20 ft bay width .

 

[SimonB]

Can you please let me know some details if can call me or send me an email I will respond with a quote.

Many Thanks

Kind Regards

Brett Harris

Technical Estimator


Graham Heath Construction Ltd

The Creamery, Wrenbury Industrial Estate, Station Road, Wrenbury, CW5 8EX

T: 01270 781158 (EXT 1018)

E: [email protected]

W:www.gh-construction.co.uk

 

[Forever Fendt]

What would a ball park price be for a fibre cement roof and z purlins for a 60ft x 30 ft building 20 ft bay width .

£3.10 p per meter for the zeds,£1.90p per foot for marley eternit big 6 fibre cement £10.50 per hundred for the self drilling screws

 

[Tinman Steels Ltd]

@Forever Fendt Out of curiosity what depth and gauge is the Z's priced on. That's seriously cheap for any size Z especially with the steel price increases at the start of January.

 

[Forever Fendt]

@Forever Fendt Out of curiosity what depth and gauge is the Z's priced on. That's seriously cheap for any size Z especially with the steel price increases at the start of January.

177 1.4 mm

 

[designanddetail]

Whatever purlins you buy, please ensure you use a minimum of 1.4 gauge. The tek screw manufacturers state that is the minimum thickness of teks to fix into properly.

 

[Tinman Steels Ltd]

I would assume it would be based on a sleeved system aswell? Personally i would go for a 1.6mm as a minimum.

 

[designanddetail]

Yes I would imagine it would be sleeved, 95% of designed cold rolled systems will need sleeves, but I would not say going to 1.6 minimum is necessary. We mostly do industrial buildings and 1.4 or 1.5 gauge is the most common, can't recall the last building we did with a 1.6 gauge rail or purlin. Quite often the design states 1.3 but then they are upgraded to 1.4 or 1.5 by the minimum spec requirements.

 

[Tinman Steels Ltd]

I always work on a 1.6mm minimum just because we have always been advised the tek screws should fix into a minimum of 1.5mm.

 

[designanddetail]

...or you work on 1.6 minimum because your a salesman and purlins are charged according to weight

 

[Tinman Steels Ltd]

If that was the case i'd recommend 2.5mm as a minimum