Simba Cultipress levelling board rams

[ConanPB]

When in work one sides hydraulic rams are farther out than the other on our 4.6m . Anyone else had this issue and how do you even them up? Could there be air in the system ? Valve needs adjustment ?
Thanks

 

[Matt L]

Cycle them all the way in and out a couple of times to re sync them. Usually have to do it every few days.

 

[s~~t shoveller]

They are a master and slave system ,one ram is bigger than the other,hence susceptible to air in the system.can't remember 100% but you will have taps on the rams and I think you turn them on,move it up and down full travel a few times holding it at full extent and then turn them off again to use...need the book really.

 

[ConanPB]

Bought secondhand and didn't get a manual with it unfortunately. We used to have a vad nz scuffle and had to bleed rams on that by holding at full extent for a while but this method didn't work on the simba . Will have a look for the taps.