Stocks turbo jet wizard

[powerontheland]

I have this fitted to my grass harrows, I have calibrated it and set width etc (well I think I have!) When I set off, after a few seconds the feed rollers stop and FAIL is displayed on the rds screen. What am I doing wrong?

 

[Alistair Nelson]

The feed could becomed bunged up with seed which jams up the metering roller. Check you have the correct feed roller in as there are different ones for different crops / rates

Or

It could be your not putting enough on for those feed rollers and they’re not going fast enough and just stall

 

[powerontheland]

The feed could becomed bunged up with seed which jams up the metering roller. Check you have the correct feed roller in as there are different ones for different crops / rates

Or

It could be your not putting enough on for those feed rollers and they’re not going fast enough and just stall

Using the proper grass seed rollers, they’re not getting jammed with seed. Tried with no seed in too and still comes up with fail. Although might try covering hopper sensor in the morning.

 

[Scragger]

Make sure you’ve got both the fan switches turned on!

 

[powerontheland]

Make sure you’ve got both the fan switches turned on!

Yes both switches on!

 

[AKA]

Fans are not running

 

[powerontheland]

Fans are not running

Fans are running when I start, need to get to the bottom of why they are stopping!

 

[AKA]

They don't like getting damp if your using it when it's raining put a sheet over it. We have replaced a fan before and carry a spare now. Check the connections are ok where the fans plug in.

 

[KB6930]

only time I've had the fans stop was due to lack of volts

 

[powerontheland]

All sorted, the cut out finger switch was causing trouble, so resorted to manual