Jon 3085
Member
- Location
- Worcester, UK
Same hereDepends if you like lifters or not. Myself for necked barley, crops where some is lodged and cutting wheat where the deer run I'll use lifters. If it's proper flat like the barley I'm half way through cutting then lifters off, header at a height it doesn't bulldoze, reel down below knife level and out, and a bit faster than forward speed lifting it ahead of the knife. Don't go too slow, and get the crop feeding itself back to the auger. That's with Nh combine. As already said find which way it goes best. It's a job only leaned by getting out there and having a go really.
Vernon
That'snot flat it's only leant over a tad! You need a New Holland with a Varifeed header!View attachment 556928View attachment 556930View attachment 556932Cutting when the sun is out always helps,and the grounds dry too.
Just have the string short enough it doesn't land.Slightly off topic.., but got some flat patches of Spring Barley after this wonderful weather we've been having Can't keep pigeons off it.. Has anyone ever used those bird scaring kites in standing crop?? Or when wind drops would they end up flattening more crop and fail to self launch again ....? Just thinking of how to keep bloody things off as Barley is a good 2/3 weeks off...
Depends how big the patches are but I have had good results on small(ish) areas with canes and black cotton, the feathered fiends will not land under criss-crossed cotton and, even if the cotton & canes goes up the combine no harm doneSlightly off topic.., but got some flat patches of Spring Barley after this wonderful weather we've been having Can't keep pigeons off it.. Has anyone ever used those bird scaring kites in standing crop?? Or when wind drops would they end up flattening more crop and fail to self launch again ....? Just thinking of how to keep bloody things off as Barley is a good 2/3 weeks off...
Make sure lifters are not bent. Push the reel forward don't run it too fast. Adjust the reel tines so they grab a little more. I try and let the combine control the header as much as possible, it tends to bulldoze less. When you go ploughing don't let the soil stay on the header it will eventually clog the intake and even worse the concave. You will find the crop will flow in better when you are traveling in different directions so be prepared to split the field and cut it the best way.
The biggest change will be made when the sun comes out. Just keep looking and adjusting things you will finish in the end.
Bg