Topcon x25 console pinout

[Stretchy]

Would anyone have the pinout of the dual key port on the back of x25 console?

 

[Northern farmer]

Do you know if it is the same as on the X30? What are you after with the connector?

 

[Stretchy]

Yes I believe they're the same, I'm wanting the NMEA signal for an external controller!

 

[Northern farmer]

I have built a cable for our X30 (AGCO C3000) for the same purpose. You should only need serial port #2 Tx from pin #2 and serial port #2 ground from pin #3. Pin #1 is for the Rx signal but should not be needed.

PS. I got the necessary guidance from this forum when I built my cable, thanks again.

 

[Stretchy]

Thanks that is very helpful.

 

[Greyster]

hi guys, tell me if you have encountered a problem with x25: part of the sensor on the left side stops working (just where the buttons are). There are already several consoles with such problems. Is this problem solved?