Ts86 rear spacers

[Farmerboyben]

Good evening.

Recently purchased a ts86 and does anyone know what this setting roughly equates to..

 

[Mydexta]

Is that not roughly 10 3/4”

I thought it was 12” outside front to inside back, then minus whatever spacers were used????
Perhaps @Howard150 or @Roy Stokes could shed some light on it

 

[Dealer]

Yep

Inside frame on rear furrow out side frame on front furrow is twelve inches

Each spacer inserted between the frame and the leg reduces the width between the 2

1 inch 1/2 & 2x quarter inch spacers

I think without measuring mine.

 

[Farmerboyben]

Ok. Front leg is set to outside of frame.

 

[Dealer]

Yes thats right

So you can move the front over all the way to take a single off

Measure the rear leg from the frame side and the inside of the frame deduct that measurement from 12" s

Most run tcn,s at 10, 3/4"

To confirm take the points off clamp 2 straight edges to the landslides and measure the distance between the 2

 

[Howard150]

They go better at 10 1/2. Keep the 1” spacer to the left against the straight beam then put another 1/2” next to it.
You seem to have a lot of random spacers there. Some have 1/2” and 3/4 spacers.
Alternatives now are 25, 20 12 and 5 or 6
Some used to put an extra inch into the frame for world style bodies which needed an extra 1” spacer.

 

[Farmerboyben]

It’s fitted with rwms and have been told that they like to plough at 11..

 

[Howard150]

Think you will find it a lot easier at 10 1/2. Drops in on itself if you get too wide.

 

[Howard150]

Think you will find it a lot easier at 10 1/2