V660 net

[copse]

have got net wrapped around feed rotor any tips how to get it out? Looks a pig of a job to me.

 

[Chae1]

Just leave it. Soon disappears.

 

[icanshootwell]

have got net wrapped around feed rotor any tips how to get it out? Looks a pig of a job to me.

I managed to get mine off with a hand held blow torch but clean baler 1st for obvious reasons, had a bucket of water on stand by just in case but didn,t need it.

 

[Andrew1983]

I managed to get mine off with a hand held blow torch but clean baler 1st for obvious reasons, had a bucket of water on stand by just in case but didn,t need it.

Second that, if it’s bad use gas to burn it off. Or as Chae says leave to to disappear..... rape straw fairly helps it go.

 

[KB6930]

Gas or leave it to wear off

 

[Drillman]

Been told a sharp chisel and a whack with a hammer.

But like everyone else says just leave it. It will soon disappear or wrap more round depending on what mood the netter is in!

 

[T C]

Soldering iron and melt a line across the rotor. Less risk of fire than a torch!

 

[Razorready]

Tourch is best i park up next to pressure washer open back door on fixed chamber baler and melt a line across rotor reach in from front and pull it out. If your next to pressure washer you can fast put it out if any chaff takes fire

 

[copse]

Ok thanks. Will have a go at it tomorrow if have time or will just leave it and see what happens.

 

[Zebbedee]

Is net on the rotor a common issue

 

[scrubbuster]

Is net on the rotor a common issue

It was on Drum's Vicon last harvest [emoji30]

 

[KB6930]

Is net on the rotor a common issue

Not really a couple of times out of 8 to 10000 bales for me both times been operator error

My neighbour seems to happen a fair bit so dunno what's going on there

 

[copse]

Is net on the rotor a common issue

First time I’ve had it happen.