What type of hyd fitting is this?

[Nearly]

Have the chance of a few cheap made up 1/4" pipes for stock.

@Mr Happy ?
@Dave W
@TripleSix
Thanks

 

[milkloss]

A lot of those on international 956 here but they're all 1/2 inch. Could be wrong but from memory they are DIN fittings

 

[Nearly]

Apparently metric dkol.
Not going to match with anything here and I'm not going to confuse the issue with adapters.

 

[cosmagedon]

Have a look on top of the nut, if it's metric they usually have 10L or 8S etc stamped in it. The number being the size and then either LL, L or S being the pressure rating. Looking at the angle of that seat though I would say your right and it's probably metric.

 

[Flat 10]

JD combines are like that I think

 

[jf850]

Have the chance of a few cheap made up 1/4" pipes for stock.

@Mr Happy ?
@Dave W
@TripleSix
Thanks

Are they JIC ?
They look like the hoses going to the rams on my Parmiter sheargrab , and I am 99% sure that's what they are . I know they are different to most grabs.

 

[AWJ26]

That's a L series metric, probably 16mm, could also be 12 or 14mm, but 16 is the most common on 1/4" hose.Use a open end spanner to measure the male threads.

 

[tinman]

Awj26 is on the money there, pretty sure it's a metric l series.