oakleaf
Member
- Location
- South coast of Ireland
Needed to change the track width of one of the tractors here which I recently did. Book said to tighten up rim bolts to 300 Nm and wheel nuts to 350 Nm which is exactly what I did.
Checked them and they were all loose so did them up to 350 and 400 but after a few days they loosened again. This time I did em up to 400 and 450 so will see what happens now.
Anyone got an idea as to how tight you should go. Obviously the book is a bit out.
Checked them and they were all loose so did them up to 350 and 400 but after a few days they loosened again. This time I did em up to 400 and 450 so will see what happens now.
Anyone got an idea as to how tight you should go. Obviously the book is a bit out.