- Location
- Bury St Edmunds, Suffolk
Me too
Today at work
- Thread starter Penmoel
- Start date
- Location
- Near Colchester
Gerbert
Member
- Location
- Dutch biblebelt
I'm off to the beach!
A few days for my local contractor, bringing sand to an excavator on a boat to fill some holes on a newly formed beach.
davidroberts30
Member
- Location
- pembrokeshire
How well does the itchypussy pull the trailing shoe??View attachment 834364View attachment 834365View attachment 834366View attachment 834367View attachment 834368View attachment 834369
Not sure where the week has gone,been a bit of everything,picked up a new work truck,had a few days with a local baling contractor pulling there rake and then back to living the dream on slurry
J428TGS
Member
yuck aa dat saat watter aboot da tractor
- Location
- Near Colchester
Got some grass seed on the old fashioned way.
First pass. then do it all again another direction.
Hope for rain now.
First pass. then do it all again another direction.
Hope for rain now.
- Location
- Hereford
It's belting down here and has been since about midday ! I failed to get all my grass seeds on but what I did will be grateful for the sky juice
- Location
- Moreton-in-Marsh, Glos
Last Barley field being rolled and pre-em sprayed.
Last edited:
Well relieved to get these 2 out today without having to remove the crank case in the tractor, that was looking a nightmare job. Just need the rest of the parts tomorrow and hopefully back running again [emoji106]
Changed the fuel filters to fill in a bit of time
Had to board a bit of the loft as they refuse to replace the leccy meter [emoji849]
We've had it here today
Shovelhands
Member
- Location
- Sunny Essex
Have you actually had any rain up at Pan Mixer Towers?
Are you on land or in furrow ? The 190 handle the plough ok ?
Running in furrow. Took a while to get the width set right. Tweeking the front furrow width a bit.
Trying to work out if the 190 pulls it as well as my previous 6080. I think the old one hung on a bit better. Having to run at higher revs at 1850 rpm. Its only done 450 hrs so hopefully it will still be improving.
Only use the big plough in the backend. Have an old 5 fr mounted for winter ploughing.
- Location
- Near Colchester
Only a mill or so at present.
As long as your land isn't too heavy or steep you will be ok. Dragging the press is similar to adding another furrow. Big old plough was cheap from another forum member.
