Tonym
Latest activity Postings About
-
-
Tonym replied to the thread Burying pipe in kitchen floor.Try the trick builders use when cutting asbestos and spray it with shaving foam. You may need a piece of lathe to guide you as you would... -
Tonym replied to the thread Folding combine headers.
-
Tonym replied to the thread Ford Ranger question.....You say it has had a wheel swap. Are you sure they are the correct offser as that will affect the steering in the way you describe
-
Tonym replied to the thread What Bale Sledge is this?.The same. Nuway were taken over by Mconnel
-
Tonym replied to the thread What Bale Sledge is this?.Definitely a Nuway Benson Used one in the sixties . problem with them was the flexible wire rope sides bowed out and when you pulled the...
-
Canteen eh? What is it they say about revenge and a dish served cold? Senokot is available in powdered form.
-
Tonym replied to the thread Combine men.Regarding checking when the auger is full in I attached a flashing led bicycle rear light to the auger with cable ties where you can see...
-
Tonym replied to the thread Skids on a hay bob.Had a Lely Gemini years ago Was on steel wheels that were never any problem except they rattled but would skid round corners without...
-
Tonym replied to the thread Used ride on mower advice.Good advice e.Had a Countax and thought it was a good mower Replaced it with an industrial Iseki. Would never go back Like chalk and...
-
Tonym replied to the thread Gripwheels.I have an old Stanhay wheel strake as they were called in the back of a shed. Slacken two nuts and drive forwards to put the lugs out or...
-
Tonym replied to the thread Dynamo to alternator.May not be the dyanmo. Could well be the regulator. Alternator conversion will do away with the regulator and charge the battery better...
-
Tonym replied to the thread Dynamo to alternator.Large terminal to battery live and small terminal though ignition light bulb to a switched live.
-
Tonym replied to the thread Water run off.I have seen a track ruined by removing the raised centre to make a gutter. The centre stabilises the two tracks and once it was removed...
-
Tonym replied to the thread Westwood t1800 cutting deck won’t engage.Just forget the original system and rewire it direct from the battery to the clutch. Run wire from the battery through the seat switch...
-
Tonym replied to the thread New Holland CR 11,90.That output would almost impossible to obtain especially in an average Canadian crop of 1.5 tonnes per acre. With a 60 ft header I...
-
-
Loading…
-
Loading…
