zr105's latest activity
-
Technically not farm, but used dairy farm materials. House rad sprung a leak. Got enough scrap laying around I can make a replacement... -
I'm earning top dad points at the minute, 3d printer knocking out loads a gates/fencing
-
Had an Ertl IH with trailer, plough and disc harrows, plastic hitch on the disc and trailer broke , dad being a metal man made new...
-
I use an outside piece of lemon tube fastened onto monitor bracket, inner pieces fastened onto different monitors, 6mm wing bolt through...
-
zr105 replied to the thread A few workshop jobs..We have a simple bracket in each cab done the same way so monitors and the likes can be moved easily, all you need is a short bit of...
-
zr105 replied to the thread what grinds your gears.Stick the pto selector lever into neutral in the cab before you get out and the shaft brake doesn’t hold the stub, atleast it works on...
-
Not mine, honest, but saw this a couple of days ago and thought it worthy of a picture. To be fair it was holding back animals in a zoo...
-
zr105 replied to the thread Not Quite Farm Engineering or a Quick Bodge..For £20 definitely hire the consaw. A 9” grinder with diamond blade can only cut around 3” deep so if your concrete is anything more it...
-
We used some stable matt off cuts from my neighbour to make my tractor steps, dog friendly. The first attempt had band but it fraid...
-
zr105 replied to the thread Not Quite Farm Engineering or a Quick Bodge..Hardly cause that much of an issue considering the tiny volume of oil needed to open and close a flat 8 and the fact it’s not likely...
-
zr105 replied to the thread Not Quite Farm Engineering or a Quick Bodge..That or a pressure relief valve the type they use on bale splitters for the net/plastic grabber. Would work so once one is closed fully...
-
zr105 reacted to Pan mixer's post in the thread Not Quite Farm Engineering or a Quick Bodge. with
Like.
You could just get a restricted orifice for one of the pipes so that the one on the drivers left always let go or picked up first, that... -
Have an Ifor Dp120 trailer here. Bought it new back about 1992, paid the extra for the loading ramps, rear jacks, and a dropside kit for...
-
I was scouring my photos, (almost) certain there wasn’t an old bath in my shed, i really should read what I type before hitting post...
-
Is cock height at the end of the cock or the base of the cock ? If it’s the end of the cock , is it when the …. oh never mind .