dundee dave
Member
is there a special spanner to remove /fit the starter nuts its a perkins tier one diesel engine nightmare to get spanner or socket on them especially one near block machine needed to feed cattle
loadall 526
- Thread starter dundee dave
- Start date
- Location
- South Devon
15mm socket on about 12 inches of 3/8 or 1/2 extentions.
ACEngineering
Member
- Location
- Oxon
15mm crows foot on 3/8 socket set is really helpful normally.
And if you replace starter with a better one not the piece of crap lucas m50 type it will go back in alot easier as it's smaller bodies.
I can supply starter if you want.
- Location
- South Devon
It's a flange nut for a 10mm stud
- Location
- South Devon
Designed for air / cordless drivers on assembly lines and saves the need for a separate nut and washer.
ACEngineering
Member
- Location
- Oxon
No its not, very common. standard size for a 10mm flanged nut or bolt
ACEngineering
Member
- Location
- Oxon
They can be very useful though, for nuts or bolts that are tight on clearance to get a ring spanner on you can replace with a flanged nut and bolt and use a smaller spanner. Also can do away with washers as flanged nuts and bolts come with either smooth face or locking faces.
Happy hillbily
Member
- Location
- Uwchaled, North Wales
A 3/8 Socket, extension, universal joint and ratchet will get it off.
I put a mhale starter on mine that I got off Andrew (AandR handling) highly recommended.
And as Andrew said, smaller body makes it much easier to fit.
I put a mhale starter on mine that I got off Andrew (AandR handling) highly recommended.
And as Andrew said, smaller body makes it much easier to fit.